1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135

52
discrete system is quite linear, the precise location of the sample points is not critical. There are,

however, a few potential pitfalls to be avoided in choosing them:

  1. Since we cannot necessarily predict the sign of the required perturbations from one


step to the next, it is often best to sample h(K) symmetrically about the nominal

operating point, K=0, rather than at the nominal point itself.

such a case.

Figure 3.24 (a) shows

  1. Samples should span a sufficiently large range in order to avoid local distortions in

h(K). A typical failure due to this problem can be seen in Figure 3.24 (b).

  1. Sample points should not consist of excessively large control perturbations.

When the

current state is far from the limit cycle, large control perturbations can result in the

biped falling over.

Including a fall as a sample can lead to a poor model.

This

situation is illustrated in Figure 3.24 (c).


Sample scaling factors of kfwd= ±5 degrees for hip pitch and klat= ±1 degree for hip roll give

acceptable linear models for our biped models over a wide variety of gaits.

[CONVERTED BY MYRMIDON]